3D-growing is one of the most simple and accessible technologies of rapid prototyping. With the help of 3D-prototyping is the design phase where we can estimate the result and make the necessary changes in the project – a three-dimensional prototyping can thus reduce the costs associated with product development.

Rapid prototyping is a modern and convenient way to make models. And we are going to tell you about one of the ways of rapid prototyping such as vacuum casting. Vacuum casting in silicone molds is a modern technology of manufacturing products from materials polymerized by chemical reactions or with low temperature curing. The advantage [...]

Rapid prototyping, vacuum casting in silicone molds and three-dimensional laser scanning are key technologies to update promptly the range of products, respond quickly to the constantly growing and changing demands of consumers, reduce training costs of production and its duration. These technologies are used at almost all stages of preparation of industrial products: when considering [...]

The most expensive mistakes – are the mistakes made in the beginning of the project, because in the initial stages the most important decisions are taken. As the project progresses, the cost of errors is reduced. At the same time, the initial level of quality control is minimal and increases as we move the development [...]

Let’s consider the most popular tools of prototyping on following criteria: speed, interactivity, specification, needed re-rendering, accessibility for all participants, possible changes. Paper prototyping. Speed of creation of the prototype: high Interactivity: None Specification: High Needed re-rendering: Yes Accessibility for all participants of the project: limited Possible changes: it is not possible Prototyping with board. [...]

Today SystemC has become actually the standard language for describing behaviors VLSI. An international group of Open SystemC Initiative (OSCI) is engaged in its development and documentation. SystemC language is based on C + + and due to the use of additional classes, provides new opportunities – the description of static and dynamic events, concurrency, [...]

Time is money. This is especially important in the development of modern electronics equipment. But until recently, all were forced to accept the fact that debugging ща firmware begins after completion of the design of hardware system. But with the development of the concept of virtual prototyping situation has changed cardinally. Existing approaches to modeling [...]